Had a bit of a play today it was raining cats & dogs so wasn't able to get out on site to weld
found abit of 3/16 tool steel and sharpened it a bit like Steve recomends
1st try I think I was holding my hand to high cause the point dug in and the hand just wanted to do sumersalts all over the ali plate
Got the hand at the right angle and to be honest what a buzz to feel it cut and watch the chip curl up in front. I think I want more
Problem the smallest tool steel I can get here in NZ is 3/16, I had a look on ebay and found this site
http://cgi.ebay.com/ws/eBayISAPI.dll...=STRK:MEWAX:IT
Has anybody delt with them.
Feed back would be great, Thanks in advance
Graham