View Single Post
  #3  
Old 12-19-2020, 01:31 AM
-Daniel- -Daniel- is offline
Steel
 
Join Date: Dec 2018
Location: Germany
Posts: 54
Default Re: Introduction and information request

Hi Daniel,

I assume you have other templates you want to use?
Basically it is up to you how much you grind your gravers depending on your needs. I have some gravers grinded down to 0,5mm face for very fine lines and dots. But i grinded those gravers so small to get a better view. The cut they produce could be done with a way larger face aswell.
With other words, as long as the geometry of your graver is correct and it cuts you can cut small lines even with a large face. But if the face is smaller you are limited to finer cuts. As long as you do standard engravings your graver wont dive deeper as around 0,2 mm per cut.

What templates do you have?
Reply With Quote