Thread: To cut Cleanly?
View Single Post
  #26  
Old 12-01-2006, 02:59 AM
Andrew Biggs Andrew Biggs is offline
Gold
 
Join Date: Apr 2006
Location: Christchurch, New Zealand
Posts: 204
Default Re: To cut Cleanly?

Hi Ken

I use about 5-10 psi with the air graver set to medium to light (not to light).

Then I sort of glide the the tool over the area holding very slightly above the surface , not on the surface. You know if it's to high a setting as it looks more like a metiorite strike as opposed to tiny dots. Then I just work the area in small circular motions. Keep yor point sharp and resharpen often.

Hope that helps a bit.

Cheers
Andrew
Reply With Quote