View Single Post
  #2  
Old 08-17-2010, 11:02 PM
chickenscratcher chickenscratcher is offline
Platinum
 
Join Date: Apr 2009
Location: North East Indiana
Posts: 341
Default Re: Excited to be here! Hello from SoCal

Hello Gary. If you want to try to engrave check on what the tools look like in Steve Lindsays tools and in GRS tools. You need only one graver to try it and and good sharpening stone and very fine sand paper (1200 -2000 grit) to polish the point. Just like sharpening a chisel or a knife it will take practice to get a good point but it's done. Get the square graver and use the info here on the foum and Steve Lindsays info and just see that with time and practice you can cut the metal. It's easy but then again not that easy or we wouldn't be so proud of the works we do. GET STARTED. chickenscratcher
Reply With Quote