View Single Post
  #1  
Old 06-05-2019, 11:24 AM
Dutch Platypus Dutch Platypus is offline
Copper
 
Join Date: Jun 2019
Location: Escondido, California USA
Posts: 5
Default Noob trying to figure out how to get started

Hi Everyone,

I'm a total noob to engraving trying to figure out how to get started. While I'm an engineer, I have dabbled in art all my life with most of my experience in drawing and airbrushing. I have been collecting fountain pens for decades and I recently started making my own with the intent to make them into little pieces of (engraved) art.

My first questions are about the equipment I need / should get. Should I start with a push hand graver to learn the feeling, or is it really worth getting an airgraver (used?). Is a ball swivel vise like the Dremel good enough for small parts (pen clips, caps) or should I really invest in a GRS ball vise? If so, what size? Are there any good places to look for used tools?

Your input will be greatly appreciated.

Best Regards,
Edwin
Reply With Quote