Thread: New here
View Single Post
Old 02-26-2018, 12:39 PM
drtyTshrt drtyTshrt is offline
Join Date: Feb 2018
Location: Outside Savannah Georgia
Posts: 8
Default Re: New here

Originally Posted by Steve Lindsay View Post
Hi drtyTshrt I like your forum name. My wife calls me that sometimes. !

Are you doing these with a rotary? It is pretty good if so with a rotary as I think it is much harder to make a clean long cut with the rotary tool and a single pointed graver. Once you figure out the graver cutting the groove it makes steads you from side to side from wiggle or shaking that happens with hand holding a rotary tool.
Thanks, there is a lot of history in that name. Do not Google it.

The steel cups and plexi mirror I did with an electric pulse engarver. Talk about wiggle and shake.

I have done a glass with a rotary and diamond bit.

I did not know how crude I was until I found this site.
All by hand, no vise, in my lap with naked eyes until I got the visor magnifier.
I have learned SO much in the past 24 hours thanks to this forum.

I plan to purchase some of your tools (palm airgraver) and I am wondering about the vise.
Do they have a built in turn table or is that a separate item?
Attached Images
File Type: jpg crude.jpg (51.3 KB, 0 views)
File Type: jpg Dale E.jpg (72.7 KB, 0 views)
Reply With Quote