Thread: To cut Cleanly?
View Single Post
  #33  
Old 12-10-2006, 06:11 AM
Tim C Tim C is offline
Platinum
 
Join Date: Apr 2006
Location: Cutler Bay, So. Florida
Posts: 293
Default Re: To cut Cleanly?

You didn't mention what it was you were cutting, copper, steel or silver?

You are at the top of the range, if you are still getting some lip raising up, keep going, you may need to go down to 45 degrees for your face angle.

Then if you like the 17 degree heel you can add that back to the heel, just drop the face a couple to compensate. It's a Tit for Tat kind of thing, take some out of Tit and add it to Tat.
As you work with different metals, you will see that different IA's work with the different metals.
Reply With Quote