Thread
:
Carving
View Single Post
#
9
06-11-2008, 01:28 PM
mckeenh
Platinum
Join Date: Mar 2008
Location: Stevensville, Mt
Posts: 812
Member's Picture Albums
Re: Carving
Nice job Phil, I noticed on the back ground That there was a first surface and then a refined surface, How did you get the clean refined surface and did you use a rotatry to get the first surfac?
Neil:yesnod:
mckeenh
View Public Profile
Send a private message to mckeenh
Find all posts by mckeenh