View Single Post
  #6  
Old 06-28-2019, 01:45 PM
Steve Lindsay's Avatar
Steve Lindsay Steve Lindsay is offline
Administrator
 
Join Date: Feb 2006
Location: Kearney, NE
Posts: 4,312
Default Re: Hello from UK, Birmingham

Hi Simon, Yes, a vise is helpful. In fact, if you are just holding your practice plate on a table and engraving, that makes it tougher. What will happen is the plate will move the smallest amount during impact jolts and power is lost a lot so that it takes more umph to cut. So with that, for now if you are without a ball vise you could just clamp your practice plates in a bench vise.

You may have found it already but here is a link to short practice exercises. https://engravingschool.com/private/tut1.htm

PS..
I am noticing the finish on your practice plate. Very nice job with the finish you have on it!
__________________
__________________________________
Steve Lindsay
AirGraver.com
EngravingArtist.com
Reply With Quote