[SEngraver]

Originally Posted by Vbj

Woot- have the air palm on its way Getting everything set up will take a bit of effort, bt can't wait. Would love to know of any short courses to get started with though, to speed things p a bit. Studied hand (hand pushed) engraving at tafe for 1 year, but it was a while ago, and this tool is a lot different.
Can travel for short course ( a week or so) , but would prefer something closer than Texas if possible ! Also planning to learn to set with it, so setting courses good too.
thanks,Victoria

Hi Vbj,

Welcome to the Engraving Forum.

Excellent choice of an airgraver there.I dont know about the courses to get started with in your part of the woods,but the link below could help some, with the using airgraver ;

http://www.airgraver.com/PalmControl.htm

http://www.engravingforum.com/showthread.php?t=2904

If you know hand/palm push engraving then palm control will be easy to use.
You get instructions with it simply follow them you cant go wrong.Anything else you wish to know ,you just have to ask on the Forum or Mr.Steve Lindsay.

There is ample advise and support here.

All the best
SE