View Single Post
  #9  
Old 07-03-2013, 08:50 PM
gmgunsmith gmgunsmith is offline
Copper
 
Join Date: May 2013
Location: Carrollton, TX
Posts: 2
Default Re: Want to start air engraver

A good 3/4 HP 4 gallon air compressor is suitable to run a combination of pneumatic systems.

As you can see in this picture I have both a 400,000 RPM rotary and a Lindsay AirGraver, each with its own regulator ganged together to support the different air pressures needed.



All of the air fittings, hoses, and regulators are available at most well equipped hardware stores such as harbor Freight, ACE, etc. I didn't find any reasonably priced regulators at Home Deport or Loews. Both Home Deport and Loews have a good assortment of small diameter pressure hose.



Here's the restoration project for an old shotgun that will be engraved later.

Last edited by gmgunsmith; 07-03-2013 at 09:08 PM. Reason: add info
Reply With Quote