Ok, got my AirGraver a few weeks ago and
did wind up winning it (
Thanks Steve!)
Been practicing and fiddling with it a bit and this is the first real project I did with it.
I started with my Box O' Happiness - the fully portable system and finished up on my bench with my microscope. That and the saw were the only things
not in the Box that I used for this.
It's a 'scrap' pendant - where I take a scrap left over from something else and use it to make something new. This one's a double scrap - the hole in it is from the first one of these that I did.
Click on the pictures for a larger version:
Things went
great! The AirGraver is doing everything I ask it to, even if sometimes I don't ask right. So far the only 'problem' I've had is I've found that I sometimes get my fat finger right over the holes when I roll the graver to the right. That puts it in 'short stroke' mode which is not (usually) what I want. Need to practice
not doing that.