[WVEngraver]

Otto,

I've scoured the net looking at all sorts of motorcycle engraving and there's no question that you are the best out there. You are mentioned on all sorts of blogs too. It is, unquestionably, true motorcycle engraving.

I've been working on my bike this winter as well and will post a photo of the engine here in a week or two. I'm hoping to give you a good run for your money!!!! Haha!!

My hat off to you sir, not only does the varying quality of sand casted aluminum make this job difficult, but the size and shape of these parts also tend to complicate.

Aside from that, you gotta love yer ride if yer willin' to get as greasy and grimy and tarnish covered as this sort a work gits ya.

Regards,
Chris Malouf