View Single Post
  #4  
Old 06-08-2009, 08:21 AM
TheEngravedLine's Avatar
TheEngravedLine TheEngravedLine is offline
Steel
 
Join Date: Jan 2008
Location: Maryland
Posts: 49
Default Re: Lasercopy transfer

I scanned in a drawing and attempted this method with an HP 2710 LaserJet but couldn't get this method to work with my printer. Since I didn't have any acetate handy, I printed on Denril vellum. When it was almost dry, I burnished it on to the metal with a Q-tip. I wish my printer would have cooperated with the method above though, since those transfers are much nicer in contrast and clarity. -Mel
Attached Images
File Type: jpg TransferExperiment1.jpg (92.5 KB, 229 views)
File Type: jpg TransferExperiment4.jpg (78.8 KB, 224 views)
Reply With Quote